How to use the heat flux in the Wire Wizard to find the optimal watts for a clapton coil?
Regarding the Coil Wrapping calculator: How is Leg Length measured? it says “total per coil,” does this mean the sum of both legs on either end of a coil? where does the ‘leg’ start?
What should I do if I am using mesh coils since there is no mesh option?
What exactly does TC precision entail? Is a higher value more desirable, or lower? The TC precision number in the Wire Wizard is an attempt to describe how easily a mod can sense the temperature of a coil. A higher number means that you should have more precise temperature control.
in the wire builder, could there be an additional area for a fused clapton? the clapton is there of course as is the staggered clapton but not the fused so its tough for new wire builders to figure out Yes, learning to use the Wire Wizard does require a bit… Read more »
No. There are rumors that I will take Steam Engine offline at some point in the near future (the exact point in time depends on when the assertion was made). Like most doomsday prophecies, this is baloney, hogwash, rubbish, etc. I just wanted to get that out there.
A square wire is a ribbon wire that has a width equal to its thickness. In other words, you can already use Steam Engine with square wires.
I have come across problems with non labled prebuilt coils. I have been using coil dimensions and its resistance to find the matierial. Which has been inaccurate. Is there a way I can do that with this site that’s more accurate? Could it be possible to add somethings similar to the… Read more »
The Youtube channel Dutch Clouds has a new tutorial for the coil calculator. I don’t understand a word of it, but I’m pretty sure it has something to do with vaping.
How do you calculate a “sweet spot”?