in the wire builder, could there be an additional area for a fused clapton? the clapton is there of course as is the staggered clapton but not the fused so its tough for new wire builders to figure out Yes, learning to use the Wire Wizard does require a bit… Read more »
No. There are rumors that I will take Steam Engine offline at some point in the near future (the exact point in time depends on when the assertion was made). Like most doomsday prophecies, this is baloney, hogwash, rubbish, etc. I just wanted to get that out there.
I have come across problems with non labled prebuilt coils. I have been using coil dimensions and its resistance to find the matierial. Which has been inaccurate. Is there a way I can do that with this site that’s more accurate? Could it be possible to add somethings similar to the… Read more »
I will be travelling to a location where there is no internet availability. I will be bringing my laptop with me. Is there a way to get the Steam Engine software installed in my laptop where I can access the software without internet connection? I just need the coil wrapping… Read more »
Is it possible to measure the lenght of each wire used for a complex build in the Wire Wizard? It would be very useful if the result would appear beside each segment.
One user asked: I want to twist Kanthal and Nickel, but your coil calculator doesn’t support mixing different materials. And another: How do you enter twisted wires where 2 different types of wire are twisted together? To me, it appears that it only allows you to use the same type… Read more »